Tabla de contenido
Publicidad
Step 14
Apply the WARNING LABEL (1L) to the TOP (D). You should be able to read the label when the TV is removed from the
å
unit. When the TV is in place, it should hide the label. Peel off the backing and apply the label as shown in the diagram.
NOTE: This is a permanent label intended to last for the life of the product. Once applied, do not try to remove it.
å
Push the RUBBER SLEEVES (2R) over the METAL PINS (1R). Insert the METAL PINS into the hole locations of your choice
å
in the ENDS (A) and UPRIGHTS (B). Set the ADJUSTABLE SHELVES (H) onto the METAL PINS.
Push two HOLE PLUGS (41P) into the holes in the BOTTOM (E).
å
Push a CAM COVER (13P) onto each HIDDEN CAM.
å
NOTE: Please read the back pages of the instruction booklet for important
å
safety information.
This completes assembly. To clean your unit, dampen a cloth with tap water and wipe.
å
And to celebrate, why not share your success story?
1R
(12 used)
Page 18
13P
A
30 lbs. total
25 lbs.
H
B
25 lbs.
2R
41P
To cover HIDDEN CAMS
(24 used)
1L
50 lbs.
D
H
B
25 lbs.
E
H
50 lbs.
total
418344
WARNING
Never use this furniture with a TV
that is too large or too heavy. Severe
injury or death can occur. The TV and
furniture will be unstable and may tip.
-The TV must weigh less than 50 lbs.
-The base of the TV must be able to
sit completely on this shelf.
Refer to instruction book for
complete safety information.
Note: This is a permanent label. Do
not try to remove. Surface will be
damaged.
A
www.sauder.com/services
Publicidad
Tabla de contenido
