Starting The Device - SPORT-ELEC Global STIM Manual Del Usuario

If you experience any tingling, switch off the device and check that the electrodes are in contact with the skin. If the
problem persists, contact the after-sales service: sav@sport-elec.com
S tarting the program with the belt
2
Once your device is connected, make yourself comfortable and switch it on following the "Starting the device"
procedure detailed in chapter III.
You can carry out your normal activities while using GlObalStim.
E nd of program
3
Once the program has finished, switch off the device and unplug it from the belt.
f f
Remove the belt, then gently remove the electrodes from your skin.
f f
Moisten them slightly with a few drops of water before replacing them onto the transparent plastic backing sheet.
f f
III. STARTING THE DEVICE
This electro-stimulation device is a state-of-the-art appliance; it complies with the standards in force.
GlObalStim can be used directly with electrodes (with 1 or both modules) or with the electro-stimulation belt onto
which 2 electrodes and 2 modules can be attached.
The "man machine" interface has been made as simple as possible.
The number displayed on the screen (from 1 to 8) indicates the program selected via the next " P " key.
The 2 graduated scales located to the screen enable you to see the power level of each module.
You will also find 6 control keys:
1 key " " (red icon) - press briefly.
ON/OFF
f f
1 "P" key to select the program - press briefly.
f f
2 pair of "+ / –" keys to adjust the stimulation power of each module.
f f
Note: A long press (1 second) on the "–" key brings the power quickly back to zero.
O n / Off
1
A brief press on the key " " turns on the device.
ON/OFF
f f
Each time it is switched on, the device carries out an auto-test on 11 safety parameters.
During the auto-test, the screen lights up for ½ second.
If an internal defect is detected, all program numbers flash.
f f
In this case, switch off your device and send it back to your retailer's after-sales service.
A long press (of more than 3 seconds) on the
f f
" P" Program selection
2
Programs are shown on the right side of the screen by the numbers from 1 to 8.
f f
Simply press the "P" button briefly one or several times.
f f
Program numbers are displayed in sequence from 1 to 8 on the screen.
As soon as a program is selected, the corresponding number is displayed.
Once the number of the required program is displayed, start your session by pressing the "+" key on the modules.
f f
P rogram
3
The program number remains lit on the screen for its full duration.
f f
When a program is running, the "P" key is inactive.
f f
However, if you have started a session and wish to change the program, you must turn off the device and then
f f
switch it back on in order to select another program.
There are 64 levels available to regulate the power from 0 to 64.
f f
- Segments from 0 to 8: there are 6 power levels, or 6 successive presses on the "+" key in order to display the
following segment.
- Segments from 8 to 10: there are 7 power levels, or 7 successive presses on the "+" key in order to display the
following segment.
12
- USER MANUAL
key " " activates the auto-test.
ON/OFF