Baxtran IB10-S Manual De Instrucciones página 26

8.1 INTERNAL COUNTING (A/D) | UF-1
1. Press the key
2. To go to the next parameter, press the key
3. To exit this mode and go back to the normal weighing, the user must press the key
8.2 CONFIGURATION OF THE LIMITS OF WEIGHT ( SUPERIOR AND INGERIOR) | UF-2
1. Press the key
2. The display will show the message " 000.00L " ( Low limit = LO)
3. Use the keys
4. Press the key
5. The display will show the message "000.00h" (Superior limit=
6. Use the keys
Note: If you need to change or modify the last digit you can place the cursor on it to do it.
7. Press the key
8. The display will show the value.
DISPLAY VALUE
A
B
C
9. Press the keys
10. Press the key
8.3 AUTO SWITCH OFF| UF-3
MODES:
AoFF 00 – Auto switch off deactivated
•
AoFF 01 – Auto switch off activated in a minute. The scale is going to switch off automatically after 1 minute of not being used.
•
• You can configure the value wished from 1 to 99 minutes.
1. Press the key
2. Press the keys
3. Press the key
26
to view the internal sums of the scale.
the screen will show the value of the voltage of the battery.
to access the parameter.
and to move the cursor and the key
to confirm.
and to move the cursor and the key
to confirm.
ESTABILITY
0 There is no need to stabilize the alarmweight to make it ring
1 The alarmweight must be stabilized to ring
0 Always 0
0 Alarm switched off
The alarm ring if it is place on the band OK
1
( between the limits Lo and Hi)
2 The alarm rings if it is situated below the
inferior limit Lo or above the superior limit
Hi
and to move the cursor and the key
to confirm.
to have an access to the parameter.
and to move the cursor and the key
to confirm.
to choose the desired number..
Hi
)
to choose the desired number.
A B C
0 0 0
(configuration of the alarm)
LO
LO
to choose the desired number.
to choose the desired number.
USER'S MANUAL IB10-S
or .
OK HI
OK HI
EN