Information On Safeties; General Precautions; Mechanical Safeties; Electrical Safeties - CELME CE L3 MN Manual Del Usuario

1.1 GENERAL PRECAUTIONS

• The cutter must be managed by skilled personnel, familiar with the instructions for use and safety
contained in this manual.
• In the case of rotation of the personnel, vocational training is necessary.
• Even if the machine comes with several safety systems, avoid setting the hands near the blade and
moving parts.
• Before the cleaning and maintenance operations, check to make sure the machine is disconnected from
the mains.
• Periodically check cable and electric elements conditions.
• Never use the cutter for cutting frozen food.
• Never carry out repairing operations personally, but apply always to skilled personnel.

1.2 MECHANICAL SAFETIES

The cutters we produce and which are described in this manual meet, as far as safeties are concerned, the
prescriptions on the risks of mechanical type issued by E.E.C. as : 2006/42/CEE. for the sanitary regulations
they comply with the rule 1935/2004/CEE.

1.3 ELECTRICAL SAFETIES

The safeties against electrical risks comply with the rule 2006/95/CEE and regulations cenelec
EN 60335-2-64.
• All our cutters include a security switch that stops the motor opening the cover to allow the blade change
in security and a self braking motor that stops blades in 3 seconds after the opening.
• The motor includes a thermal overload protection.
• On the low voltage circuit is set a relay for restarting the machine whenever a fortuitous lack of current
occurs.
Due to the perfect insulation of all the electric elements and the remarkable resistance of all the materials
used, our machines can be installed to work inside moist premises (protection IP23)
WARNING: In conformity with point 1.7.2. "Instructions on further risks" contained in the E.E.C. regulations
2006/42/CEE, these protections and safeties strictly comply with these regulations.
We point out however that the above mentioned protections, even if they sensibly reduce both the possibility
and extent of the damage, do not eliminate fully the risk of cutting.
Technical features of the series of cutters CE L line":
• Direct transmission
• Possibility of continuous work with overload temperature control on motor
• Stainless steel bowl with patented surface treatment no sticking and without corrosion
• Hub with tempered stainless steel blades
• Safe in the use, cleaning and maintenance
•
Maximum hygiene, with a project and realisation of all parts without edges in stainless steel

1) INFORMATION ON SAFETIES

2) TECHNICAL FEATURES

8