Level Adjustment; Installation Of Non-Skid Pads (Optional) - LG WDN12515BD Manual Del Propietário

I nstallation

Level adjustment

Lock nut
Adjustable feet

Installation of non-skid pads (optional)

Some floor surfaces are too slippery to
prevent the washer from moving on the floor
during heavily unbalanced loads. While it is
normal for an occasional load to be out of
balance, excess noise and vibration can
result from the washer moving out of position.
If these conditions are encountered, follow
the instructions below for installation of the
non-skid pads. These pads will help prevent
the washer from moving during heavy out of
balance conditions thereby reducing noise
and vibration.
1. Adjusting the washing machine level properly prevents
excessive noise and vibration.
Install the appliance on a solid and level floor surface,
preferably in a corner of the room.
NOTE: Extend the feet no more than necessary to level the
2. If the floor is uneven, adjust the adjustable feet as
required. (Do not insert pieces of wood etc. under the
feet)
Make sure that all four feet are stable and resting on the
floor and then check that the appliance is perfectly level.
(Use a spirit level)
❊ After the washer is level, tighten the lock nuts up towards
of the base of the washer. All lock nuts must be tightened.
NOTE: If there are vibration and noise during the spin cycle,
Adjustable feet
❊
Diagonal Check
When pushing down the edges of the washing machine top
plate diagonally, the machine should not move up and down at
all. (Please, check both of two directions)
If machine rocks when pushing the machine top plate
diagonally, adjust the feet again.
• Non-skid pads
✼ Place the pads under both front feet.
washer. The more the feet are extended, the more the
washer will vibrate.
re-check the leveling of the washer, adjust the feet as
required, and tighten the lock nuts securely to prevent
changes in adjustment.
Run the washer with a test load to make certain your
washer is properly leveled. Put approximately 6 pounds
of laundry in the machine. Then, press POWER,
RINSE+SPIN, and START/PAUSE, in that order.
When the machine spins at high speed, verify that it is
stable. If not, adjust
This side up
Stick adhesive side to floor
Remove backing
9