Cleaning & Maintenance - Honeywell HL Serie Manual Del Propietário

CLEANING & MAINTENANCE
Appliance Maintenance:
1. Turn off the appliance before disconnecting the power supply.
2. Only clean the appliance with a soft dry cloth.
Dust Filter Maintenance:
The dust filter is to be cleaned every two weeks to maintain air cooling efficiency. Please follow the
below instructions for cleaning the dust filters:
1. Switch off and unplug the air conditioner from the electrical outlet.
2 . Remove the Upper Filter/ Grill and unscrew the Lower Filter/ Grill and carefully remove.
3 . Gently wash using water and/ or diluted liquid dishwashing detergent. Rinse thoroughly and gently
shake excess water from the filters. Make sure the filters are dry before reinstalling.
Note: You may use a vacuum cleaner to remove dust.
4. Replace the Upper Grill onto the unit, and reinstall the Lower Grill with the screws.
WARNING: DO NOT power or operate the Air Conditioner when cleaning or when any or both of the
Rear Grills are removed from the unit, or if there is a loose-fitting Rear Grill(s). DO NOT attempt to
handle or touch any of the parts or wiring inside the air conditioner after the Rear Grill(s) are removed
from the unit. Doing so can cause serious injury or electrical shock.
End of Season Storage & Maintenance:
If the appliance will not be used for a long time, follow these steps:
1. Be sure to drain the left-over water condensation. Remove the lower drain plug and use a
shallow pan to collect the water (make sure to replace the drain plug when finished).
2. To dry excess moisture, run the unit in Fan only mode for 30 minutes before storing.
3. Turn off and unplug the air conditioner from the power supply.
4. Remove the dust filter and clean with water. Dry the dust filter and then reinstall.
5. Disconnecting the Window Installation Kit:
• Remove the Exhaust Hose from the unit.
• Remove the Window Bracket, Window Bracket Panel Adapter and Exhaust Hose Connector.
• It is recommended to store the Window Kit parts in a bag together with the Remote Control
and placing them together with the air conditioner unit.
•
If needed, you can clean the Window Kit with a damp cloth and water before storing.
Make sure all parts of the Window Kit are dry before storage.
6. Cover the air conditioner with a cloth/ plastic bag before storage, to protect from dust and
scratches collecting on the surface of the unit.
7. It is recommended to coil the power cord before storing to ensure the cord is protected from
bents and creases.
8. Store the air conditioner in a cool, dry place, away from direct sunlight.
EN 10