CLEANING & MAINTENANCE
Appliance Maintenance:
1.
Turn off the appliance before disconnecting the power supply.
2.
Only clean the appliance with a soft dry cloth.
Dust Filter Maintenance:
The dust filter is to be cleaned every two weeks to maintain
air cooling efficiency. Please follow the below instructions
for cleaning the dust filters:
1.
Turn off the appliance and remove the upper and
lower dust filters.
2.
Rinse it in lukewarm water. After cleaning, dry in
a shaded and cool place, then reinstall.
End of Season Storage & Maintenance:
If the appliance will not be used for a long time, follow these steps:
1.
Be sure to drain the left-over water condensation. Remove the lower drain plug and use a
shallow pan to collect the water (make sure to replace the drain plug when finished).
2.
To dry excess moisture, run the unit in Fan only mode for 30 minutes before storing.
3.
Turn off and unplug the air conditioner from the power supply.
4.
Remove the dust filter and clean with water. Dry the dust filter and then reinstall.
5.
Disconnecting the Window Installation Kit:
Remove the Exhaust Hose from the unit by pressing the release button located on the right
side of the Hose and then sliding the Hose to the right side.
Remove the Window Bracket, Window Bracket Panel Adapter and Exhaust Hose Connector.
It is recommended to store the Window Kit parts in a bag together with the Remote Control
and placing them together with the air conditioner unit.
If needed, you can clean the Window Kit with a damp cloth and water before storing.
Make sure all parts of the Window Kit are dry before storage.
6.
Cover the air conditioner with a cloth/ plastic bag before storage, to protect from dust and
scratches collecting on the surface of the unit.
7.
It is recommended to coil the power cord before storing to ensure the cord is protected from
bents and creases.
8.
Store the air conditioner in a cool, dry place, away from direct sunlight.
EN
9
Upper Dust Filter
Lower Dust Filter