Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
14. Grasp the flats of the Housing in vise jaws with the
output spindle downward. Remove the Rear Liner
Cover Assembly and put grease in the central open-
ing of the Cover. (Refer to Dwg. TPD1289)
15. Reinstall the Cover Assembly and use a hex wrench
to push it below the threads at the rear of the Hous-
ing. (Refer to Dwg. TPD1290)
PUSH DOWN
MAINTENANCE SECTION
GREASE
(Dwg. TPD1289)
(Dwg. TPD1290)
16. Install the Housing Cap (42) and using the spanner
plug furnished in the Tool Kit, tighten the Cap be-
tween 5 and 6 ft–lb (8 and 9 Nm) torque. (Refer to
Dwg. TPD1291)
SPANNER PLUG
17. Make certain the Drive Shaft rotates freely and then
fill the mechanism with fluid and reassemble the tool
as instructed in the section, CHANGING THE
MECHANISM FLUID.
CLOCKWISE TO TIGHTEN
(Dwg. TPD1291)
Publicidad
Tabla de contenido
