BLACK&DECKER CST1200 Manual De Instrucciones página 7

OPERATE THE TRIMMER/EDGER
• To turn trimmer on, pull the lock out button, shown in Figure 1,
backwards and, then squeeze the trigger switch. To turn the
tool off, release the trigger.
• Slowly swing trimmer side-to-side as
shown in Figure 5.
• To convert for maintenance edging,
turn off the tool. (See Figure 6)
Holding the trimmer with one hand by
the auxiliary handle, grasp the trimmer
head collar and push in direction of
arrow and rotate the trimmer head
clockwise (when viewed from the
switch end) until it stops, (half turn),
release your hand. The tool is locked in
the edger position.
5
6
7
Rotate the wire edge guide
forward and down into place
before edging, as shown
in Figure 7.
• To operate as a maintenance
edger, position trimmer above
sidewalk as shown in Figure 8.
• Return to trimming position by
turning the tool off, push in
direction of arrow and rotating
the trimmer head counter
clockwise until it stops. When
using the tool in the trimmer
mode you may choose to fold
the wire edge guide up out of
the way.
CUTTING LINE
LINE FEEDING
Your trimmer uses .065 in. (1.65 mm) diameter, ROUND nylon
line to cut grass and weeds quickly and easily. During use, the tip
of the nylon line will become frayed and worn and the special self
feeding line hub will automatically feed and trim a fresh length of
line. Cutting line will wear faster and require more feeding if the
cutting or edging is done along sidewalks or other abrasive
surfaces or heavier weeds are being cut. The advanced
automatic line feeding mechanism senses when more cutting line
is needed and feeds and trims the correct length of line
whenever its required. DO NOT BUMP unit on ground in attempt
to feed line or for any other purposes.
7
8