Connection; Programming - Denwa iP Access Manual Del Usuario

Connection

1. Put the wire to Ethernet in the RJ45 connector (CN12)
2. Connect a power source of 12 Vac/dc - 1 A at CN1 terminal block.
The polarity of the connection is indistinct.
3. If there is an open door circuit (with external power), pass this circuit through the
CN13 or CN14 terminal blocks , they are normal open contacts , that closes when it
receives the corresponding signal.
The contact of CN13 can works as normal closed connecting properly mini jumper
JP2
NOTE: the separated power supplies drawed in the diagram is just for clarity, but
everything can be supplied from the same power supply

Programming

The iP Access has a internal web server that response in the 8085 port.
The programming of configurable parameters of the iP Access can be done through a
web browser (Internet Explorer, Firefox, etc).
With the initial boot, the iP Access has the IP address 10.0.0.100, so, to access to
programming, enter the following address in the browser address bar:
http://10.0.0.100:8085
Página 21 de 33
Manual de Portero IP v 8.0
DENWA IP Access
Versión de software (desde) 3.17