Maintenance; Detachable Blower Intake - Craftsman CMXEVBE176060 Manual De Instrucciones

MAINTENANCE

Detachable Blower Intake (Fig. W)
WARNING:
!
To reduce the risk of injury from accidental starting,
unplug power cord before changing or cleaning filter
or foam pad.
After using the Detachable Blower of your Wet/Dry Vac,
examine the bottom of the Blower for dust and debris.
Check to see if the Intake to the Blower has debris stuck to
the plastic vents and Foam Pad.
To clean the Foam Pad under the Intake Shield of the
Detachable Blower:
1. Remove and retain the Three Screws holding the
Intake Shield.
2. Lift the Intake Shield from the Vac.
3. Remove the Foam Pad from the Intake Shield.
4. Clean the Foam Pad in warm soapy water or brush
debris away. Allow Foam Pad to dry.
5. Examine Foam Pad for damage or wear. If it needs to
be replaced, the replacement Foam Pad is listed in the
Service Parts Section of this manual.
6. Reassemble Foam Pad into the Intake Shield.
7. Reinstall the Intake Shield using the Three Screws that
were removed in Step 1.
The Unit is ready for use.
WARNING:
!
Do not operate without installing the intake shield.
14
SP7092-1 12 & 16 GALLON.indb 14
Fig. W
Foam Pad
Intake
Shield
Screws (3)
9/13/19 9:07 AM