X-LITE X-602 Seguridad E Instrucciones página 11

Defogging function
While wearing the helmet, open the visor onto the first notch and press the Double Action
button as shown in Fig. B. Now close the visor.
In this position, the mechanism keeps the visor open to a minimum to improve the circu-
lation of air and facilitate defogging, especially at low speeds or during short stops.
To deactivate Double Action, press the button as shown in Fig. C to bring it back to the
neutral position.
Visor-lock function
While wearing the helmet, close the visor and press the Double Action button as shown
in Fig. C.
In this position, the closing mechanism on the visor is strengthened so that it will not open
accidentally, even at high speeds.
To disenable the visor-lock mechanism, press the button as shown in Fig. B to bring it back
to the neutral position.
Attention! It is recommended that you limit your use of the visor-lock function, since unex-
pected events may require you to open your visor immediately.
Attention! In the event of an emergency, the Double Action visor-lock may be disenabled
by lifting the visor as normal, and pressing slightly harder than usual on the visor flap.
• RACING COMFORT - INNER COMFORT PADDING
1 Cheek pad removal (Fig. 4)
1.1 Pull up the visor and unfasten the chin strap (see relative instructions).
1.2 Hold the top of the cheek pad and pull it inwards to unhook the first button (Fig. 4A).
1.3 Pull the lower part of cheek pad inwards to unhook the second and third button pay-
ing attention to remove the latter from the slot of the rear roll-neck, then unhook the
forth button placed at the end of the lower part of the cheek pad (Fig. 4B).
1.4 Repeat step 1.2 and 1.3 on the other side of the cheek pad.
2 Liner removal (Fig. 5)
2.1 Hold the central area of the rear roll-neck and pull it towards the inside of the helmet
in order to slide out the central flap located between the polystyrene and the shell.
Then, unhook the left and right side flaps from their fastening seats, remove the rigid
side flaps of the rear roll-neck located between the polystyrene and the shell (Fig. 5 A
and 5B).
2.2 Hold the front area of the liner and pull it towards the inside of the helmet in order to
slide out the central flap located between the polystyrene and the shell, then unhook
the left and right side flaps from their fastening seats (Fig. 5C).
2.3 Completely remove the liner from the helmet.
3 Liner assembly (Fig. 5)
3.1 Insert the liner into the shell of the helmet and fit it symmetrically well against the
base.
3.2 Check that the flap in the front area and the side fastening flaps match up and,
once you have verified the whole assembly, first fasten the left and right side flaps
into their fastening seats, then insert the central flaps between the polystyrene and
the shell (Fig. 5C).
11