X-LITE X-602 Seguridad E Instrucciones página 13

WARNING!!!
- Make sure that the system has been assembled properly by pulling up and down
thevisor.
- Scratched visors and inner visors can cause reduced visibility and must therefore
bechanged.
- Intense sweating /breathing, the use under particular weather conditions (low temper-
atures, and/or high humidity and/or sudden changes in temperature or heavy rain)
and intense and prolonged use may affect the performance of the system and cause
the fogging or formation of condensation on the inner visor.
- In such cases, after using the helmet and to restore the system efficiency, remove the
inner visor from the helmet visor and let it dry with dry and lukewarm air. The same
procedure must be applied to the helmet, in order to dry out humidity in case it has
formed up as a consequence of the conditions described above.
2 DISASSEMBLY
2.1 Remove the visor equipped with inner visor.
2.2 Widen the visor: the inner visor will come off automatically.
MAINTENANCE AND CLEANING
Remove the inner visor from the visor. Using a damp and soft cloth, gently clean it with
neutral liquid soap. Remove the soap under running water.
Dry the inner visor with dry and lukewarm air without wiping it.
To keep the features of the inner visor in good conditions over time, let the helmet dry in a
ventilated and dry place with the visor open after use.
Keep it away from heat sources and store it in a dark place.
Do not use solvents or chemical products.
• WIND PROTECTOR
This accessory allows improved helmet performance under certain conditions of use.
The Wind Protector prevents annoying infiltration of air under the chin area. See Fig. 9 for
assembling and disassembling.
ATTENTION!!!
The Wind Protector is easily removable. You can check the correct assembling of this
accessory by pulling it gently towards the inner part of the helmet with your thumb and
forefinger. If it moves, repeat the assembling operations.
13