X-LITE X-602 Seguridad E Instrucciones página 12

3.3 Repeat the same operation at point 3.2 for the rear roll-neck of the liner, paying atten-
tion to fit the rigid side flaps of the rear roll-neck between the polystyrene and the shell
(Fig. 5 A and 5B).
3.4 Carefully adjust the liner until it adheres well to the shell.
3.5 Make sure that the liner in the front area is well inserted under the window edge trim
and that the rear roll-neck of the liner is fitted under helmet base edge.
4 Cheek pad assembly (Fig. 4)
4.1 Make sure that the cheek pad is in the correct position so that all the snap buttons are
in line with their housings.
4.2 Hook the four buttons, paying attention to insert the third button (see fig. 4 B) in the
buttonhole of the rear roll-neck
Warning: the buttons are not hooked until a click is heard.
4.3 Check that the strap comes out properly from the cheek pad.
4.4 Repeat steps 4.1 to 4.4 on the other side of the cheek pad.
ATTENTION!!!
- If your helmet is equipped with the D-Ring retention system, pull it down as
indicated in the attached D-Ring label.
- Take out the inner padding only to clean and wash it.
- Never use your helmet without having correctly and completely replaced the inner
comfort padding as well as the cheek pads.
- Wash gently by hand, with mild soap andlukewarm (max 30°C) water only.
- Rinse in cold water and let dry at room temperature, away from direct sunlight.
- Do not machine wash.
- Inner polystyrene is easily deformed to absorb impact energy bypartial alteration or
destruction.
- Wipe clean with a damp cloth, then let dry at room temperature, away fromdirect
sunlight.
- Never modify the inner components of the helmet polystyrene
- Never use any tools to carry out the above-described operations.
• NFRS – NOLAN FOG RESISTANT SYSTEM
1 INNER VISOR ASSEMBLY
1.1 Remove the visor.
1.2 Remove the protective film from the inner visor on the face in contact with the visor.
1.3 Check that the inner surface of the visor is clean.
Attention: the presence of dust between the visors can produce scratches on both-
surfaces.
1.4 Rest one side of the inner visor on one of the visor pins and hold it in position (see Fig. 6).
1.5 Open the visor and fasten the other side of the inner visor to the second pin
(seeFig. 7).
1.6 Release the visor.
1.7 Remove the second protective film from the inner visor.
Attention: Check that both visors are tightly connected and do not move; if they do,
adjust the spring pins using a screwdriver to set the adherence (Fig. 8).
1.8 Fit the visor in the helmet.
12