Push-Button Hand Control; Cleaning & Storage - Mangar International Airflo Mk3 Instrucciones De Uso

B
C
D
Cleaning
Unless contamination is suspected, periodic cleaning is all that is recommended. The Airflo should be
cleaned/disinfected as follows:
• Unplug the Airflo from the battery charger. Clean the external surfaces using a non abrasive damp
cloth with warm water. Wipe dry thoroughly with a dry towel before reconnecting to the battery charger.
Do not allow moisture to enter any part of the compressor.
• Do not use solvent-based products.
Disinfecting
• Pre-clean using a damp cloth and then disinfect using a hard surface alcohol impregnated wipe.
Storage
• When not in use, store in a dry place together with these instructions. To maintain the battery when
being stored for long periods, put the Airflo on charge overnight every 3 months.
Simple solutions for everyday independence
2-Way Hand Control
Connect the hand control (A) to the socket (B).
DO NOT connect any other plug to this socket.
• Press the 'Up' button (C) to raise.
• Press the 'Down' button (D) to lower.
NOTE: When either the 'Up' or 'Down' buttons are
pressed, the internal microprocessor carries out a
battery voltage check and if the voltage becomes
too low, the 'Down' button will not work. This
feature will always ensure that the seat of a Mangar
International bathing product cannot be lowered
into a bath if there is insufficient battery power to
raise it again.
A
When inflating Mangar International products
which are not fitted with a pressure relief valve,
the compressor will stop automatically once the
product is fully inflated.
5
Airflo Mk3
- fig. 5
5