Service And Repairs - Leister GROOVER Manual Del Usuario

Maintenance
• After use, disconnect the tool from the power supply. Remove the cutting blade cover (14). Clean the cutting
blade, cutter housing and dustbag (17). Refit the cutting blade cover (14).

Service and Repairs

• The carbon brushes of the tool's motor should be checked after about 1600 hours running time by your Service
Centre.
• Repairs have to be carried out by authorised Leister Service Centres only. They guarantee a specialized and
reliable repair service within 24 hours using original Leister spare parts.
Warranty
• For this tool, the guarantee or warranty rights granted by the relevant distributor/seller shall apply. In case of gu-
arantee or warranty claims any manufacturing or workmanship defects will either be repaired or replaced by the
distributor at its discretion. Warranty or guarantee rights have to be verified by an invoice or a delivery document.
Heating elements shall be excluded from warranty or guarantee.
• Additional guarantee or warranty claims shall be excluded, subject to mandatory provisions of law.
• Warranty or guarantee shall not apply to defects caused by normal wear and tear, overload or improper handling.
• Warranty or guarantee claims will be rejected for tools that have been altered or changed by the purchaser.
Conformity
(Pursuant to the EC Machinery Directive 2006/42; Appendix II A)
Leister Technologies AG, Galileo-Strasse 10, CH-6056 Kaegiswil, Switzerland confirms that this product, in
the version that has been marketed by us, is in compliance with the requirements of the following EC Directives.
Designation:
Model:
Directives:
Harmonised standards:
Name of the documentation official: Volker Pohl, Manager Product Conformity
Kaegiswil, 14.08.2014
Disposal
Power tools, accessories and packaging should be sorted for environmental-friendly recycling. Only for
EC countries: Do not dispose of power tools into household waste! According to the European Direc-
tive 2002/96 on waste electrical and electronic equipment and its incorporation into national law,
power tools that are no longer suitable for use must be separately collected and sent for recovery
in an environmental-friendly manner.
14
Seam groover
Groover
2006/42, 2004/108, 2006/95, 2011/65
EN 12100,
EN 55014-1, EN 55014-2, EN 61000-3-2, EN 61000-3-3,
EN 62233, EN 60745-1, EN 50581
Bruno von Wyl, CTO Andreas Kathriner, GM