Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS – ELECTRIC DRYER
Install Ventwork
1. Install exhaust hood. Use sealing compound to seal exterior
wall opening around exhaust hood.
2. Connect exhaust vent to hood. (Exhaust vent MUST fit inside
hood.) Secure vent to hood with 4" (10.2 cm) clamp.
3. Run exhaust vent to dryer location. Use the straightest path
possible. Avoid 90° turns. Use clamps to seal all joints.
Prepare Dryer
1. Remove tape from dryer cabinet. Open dryer door and
remove tape from dryer drum. (Not all dryer drums are
taped.) Remove drying rack, if included. Turn dryer drum
counterclockwise to make sure all tape was removed. Wipe
drum with damp cloth to remove any dust.
2. Take two cardboard corners from dryer carton and place
them on floor in back of dryer. Firmly grasp body of dryer
and gently lay it on its back on the cardboard corners.
3. Start to screw legs into holes by hand. Use an adjustable
wrench or 1" (2.5 cm) hex-head socket wrench to finish
turning legs until you reach the ridge with the diamond
marking.
diamond
marking
4. Stand dryer up on cardboard or hardboard.
7
Publicidad
Capítulos
Tabla de contenido
