koban KDP6 Manual Del Usuario página 31

Cut the cable entry knock-out by a
plier (See FlG.7-A), and feed cables
through cable entry knock-out and
rubber gasket, then refer to wiring
Put wood screws lnto the rubber
washer, and fix the bottom case on
the wall or ceiling, then cover up
NOTE
• DO NOT take off the rubber strip
voluntarily and make sure it lies
in the front cover perfectly (See
FIG.8).
• Click sound shows the upper
hook has been fastened into slot
(See FIG.9-A),and a second click
www.grupotemper.com
Wall presence detector
diagram (See FIG.5) to connect
power cables, and please be noted to
strip off 6- 8MM of cable sheathing
(See FIG.7-B).
the front cover and tighten it with
screws. (See FIG.8)
sound shows the lower hook
has been fastened into slot ( See
FIG.9-B). Please make sure front
cover is lockad wall on bottom
case (Sea FIG.9-C),lf not (See
FIG.9-D),water wlll enter lnto
the inside of product to cause
danger of human body.
Instructions manual |
KDP6
31