DeWalt DW870 Manual De Instrucciones página 6

DW870,220/383823 5/3/02 1:29 PM
• NEVER CUT MAGNESIUM WITH THIS TOOL.
• Use chop saw in a well-ventilated area.
• Turn chop saw off before removing any pieces from the base.
• DO NOT CUT ELECTRICALLY LIVE MATERIAL.
• NEVER USE A CIRCULAR SAW BLADE IN THIS CHOP SAW.
DO NOT USE TOOTHED BLADES.
• DO NOT OPERATE THIS TOOL NEAR FLAMMABLE LIQUIDS,
GASES OR DUST. Sparks from cutting or motor may ignite dust
and fumes.
SAVE THESE INSTRUCTIONS
Power Supply
Be sure your power supply agrees with the nameplate marking.
120 volts, "60 Hz" means alternating current (normal 120 volt, 60
Hz house current).
A voltage decrease of more than 10% will cause a loss of power and
overheating.
Switch
To start the tool, depress the trigger switch shown in Figure 1. To
turn the tool off, release the switch.
Features and Benefits
• AC/DC permits use with a DC power source such as a welder.
• Switch handle is human engineered for maximum convenience
when the saw is used on a bench, or on the floor.
• Lightweight, sure-grip carrying handle, and fold-down design
combine to make it easy to carry the machine from job to job.
• Rugged steel base with rubber padded feet provide durability
and vibration-free operation for stable cutting.
Page 2
2
FIG. 1
FIG. 2
GEAR
FLANGE,
SHAFT
INSIDE
FLANGE, OUTSIDE
TRIGGER SWITCH
BLADE LOCK
LEVER
ABRASIVE WHEEL
ADAPTER
WASHER
HEX HEAD BOLT