DeWalt DW870 Manual De Instrucciones página 8

DW870,220/383823 5/3/02 1:29 PM Page 4
OPENING ADJUSTMENT FIG. 4
Remove both fence bolts. Move fence forward or backward to
desired location. Install both bolts. Tighten both bolts.
To Carry
FIG. 5
Fold down unit to position where you can attach chain to pin on tool
arm (Fig. 4).
Cutting Capacity
The wide vise opening and high pivot point provide cutting capacity
for many large pieces. Use this chart to determine total maximum
size of cuts that can be made with a new wheel. Recommended
applications are: metal studs, electrical conduit up to 4" diameter,
bar stock and reinforcing bar up to 3/4" diameter.
NOTE: As cutting width increases, cutting height decreases.
CAUTION: CERTAIN LARGE , CIRCULAR OR IRREG-
ULARLY SHAPED OBJECTS MAY REQUIRE ADDITIONAL
FIG. 6
HOLDING MEANS.
INDEX LINE
CAUTION: DO NOT CUT MAGNESIUM WITH THIS TOOL.
Maximum Cutting Depth
To obtain maximum cutting depth, move the fence to the rear
position (Fig. 5).
NOTE: A new wheel, when pushed all the way down, will extend
below the base and cut into the work surface.
FIG. 7
Degree Setting
Align the index line stamped in the base with the appropriate
degree for the desired angle of cut (Fig. 6). For very accurate cuts,
use a protractor.
BRUSH
WEAR LINE
0.3"
7.62 mm
4