Yakima Spare Joe Guia De Inicio Rapido página 2

READ THESE CAUTIONS BEFORE INSTALLATION
Improper attachment of this product may result in damage to your carrier, bicycles, vehicle, or vehicles driving
• Always use extra strap to secure bicycles to carrier. (Extra strap is not included)
• Straps require tightening before each use, and periodically during transit.
• Never drive off-road with bicycles loaded.
• Load is limited to 2 bikes with a total of no more than 70 lbs.
• Reducing speed on corners or rough roads will reduce the risk of damage to bikes or vehicle.
• Do not let bicycle tires or straps hang near vehicle's hot exhaust.
• If any strap appears worn or frayed, discontinue use.
• Never modify any carrier parts in order to make them fit.
• Make sure spare tire is securely attached to vehicle and fully inflated before installation of the SpareJoe.
Determine which direction the support arms should face.
The SpareJoe comes pre-assembled in the right mounting position.
If your vehicle matches this position, skip to step 3.
left mount
Reposition the support arms to fit your vehicle:
• For easiest
assembly, place the
main unit on a flat
surface.
• Open the red hub
levers to loosen the
frames.
• Unscrew the hub
cap and remove the
center pin.
1033270A-2/12
behind you. It is your responsibility to ensure a safe installation.
SPARE JOE ASSEMBLY
center mount
• Remove Support arms and readjust to the
desired position.
• Reinsert center pin and tighten hub assembly.
right mount