jbc DR560-A Manual De Instrucciones página 3

Connection
Tip
Ref. C560003
Desoldering process
When desoldering, use a tip with a diameter larger than the pad being desoldered. This will achieve
maximum suction and thermal efficiency.
1. Apply the tip so that it fits
over the component terminal.
The vacuum pump will continue to run for a few seconds. This makes sure that the vacuum
circuit is completely empty. If there are any solder remains left on a terminal, just resolder it
with fresh solder and repeat the desoldering operation.
Desoldering Iron
Ref. DR560-A
to stand
to desoldering module
2. When the solder liquefies,
gently rotate the tip so that the
terminal can be lifted off.
w w w.jbctools.com
Suction Filter
Ref. 0821830
Supplied with desoldering module
3. Then press the vacuum
pump button long enough to
suck up the solder.
3