Important - jbc DR560-A Manual De Instrucciones

Changing the heating element
For this operation, turn off the station or disconnect the tool and wait until the tool temperature
drops to room temperature.
1. Removing
Loosen the deposit lid (a), remove the screw (b) and withdraw the heating element (c).
2. Placing
Insert the new one (a), tighten the lid (b) and then the screw (c).
a
!

Important

Before placing, make sure to
insert the internal gasket into
the Solder Collector.
c
!
Important
For a proper connection it is
essential to insert the car-
tridge as far as the mark.
mark
(Ref. DSV-DR)
Recommended: Remove the
lid in a vertical position and
follow the cleaning guideli-
nes in the tool and station
manuals.
b
Compatibility
The DSV-DR also works with
the previous version DR5600
Desoldering Iron (Ref.
5600010). In this case, you
must take out the washer with
a pliers.
w w w.jbctools.com
washer
5