Carry Position (E); Safety Gloves; Start / Stop (F); Operation (G) - Rothenberger R 550 Instrucciones De Uso

 Move to the top position: Pull out the lever, pull the sleeve downwards, insert the lever and
lock the sleeve again.
R750:
The handle can be turned forwards to allow the machine to be pulled more easily.
 Push the sleeve downwards, pull out the lever, turn it through 180° and insert it again.
Turn the knurled bushing for securing or blocking and check that the clamping lever
cannot be pulled!
6.5 Carry position
The handle can be locked for carrying. To do this push the handle and pull the lock. To release
the lock, press the handle briefly.
6.6

Safety gloves

Information brochure on safety gloves according to EC guideline 89/686/EWG.
Appendix II, Section 1.4 for minimal hazards only.
This pair of gloves is exempted under Chapter II, Article 8, Paragraph 3 of the prototype test and
is assigned to Category 1. From this it is assumed that their effectiveness against minor hazard-
free risks has been perceived.
The protection class is determined by the requirements, which may be of a mechanical, chemi-
cal or thermal nature or due to similar influences that do not call for a Category 2 protection
class. A risk analysis must be carried out through a wearer trial if the required size is to be speci-
fied so that the glove fits. When using accessory parts, such as undergloves, it should be noted
that function may be negatively affected.
The gloves must be properly stored, i.e. in boxes in dry spaces. Influences such as humidity,
temperature, light and natural changes in materials over time may lead to changes in the char-
acteristics. A shelf life cannot be specified, because that will depend on the the degree of wear,
and the amount and location of use.
Care with commercially available cleaning utensils (e.g. brushes, polishing cloths, etc.) is rec-
ommended. Washing or chemical cleaning requires prior consultation with an authorized tech-
nical workshop.
The manufacturer can accept no liability for changes in the characteristics. Before each time the
gloves are used, check to make sure they are intact.
6.7 Start / Stop
 Switch the motor on and off at the switch:
Motor off
 Start the spirals turning by pressing the handle.
6.8 Operation
Please ensure that the protective hose is attached to the machine.
 Insert a suitable spiral, secure the protective hose and secure a suitable tool.
 Position the machine max. 50 cm in front of the opening of the pipe you wish to clean. Set
the machine to turn clockwise at the On/Off switch.
 Insert the spiral approx. 50 cm into the pipe. Press the handle. The spiral will start to turn.
Guide the spiral only with the supplied special safety glove.
 Release the handle and push the spiral further into the pipe. Repeat this process until you
feel resistance; this means you have reached the blockage!
 Pull the spiral out of the machine until the spiral is prestressed into a bend (working bend).
18
All manuals and user guides at all-guides.com
Turn clockwise;
remove blockages
ENGLISH
(E)
(F)
Turn anti-clockwise,
return jammed spirals
(G)