Gewiss Chorus GW 10 754 Manual De Instrucciones página 24

1. Power the device via the BUS.
2. Follow one of these procedures for the system to acquire the device:
• Automatic acquisition:
- select the "Find/Configure" or "Scan" command on the "System" menu;
• Manual acquisition (factory default settings have been changed):
- select the "Add device" menu from the "System" menu;
- press the programming key briefly (< 2 seconds). The programming LED
turns on during the acquisition process (figure A).
The acquired device is listed with an assigned number, product code and
list of channels, on the "Devices" page.
Insert the device in a Chorus 3-module support, ensuring the rear programming LED
is at the bottom.
Fix the support to the chosen container (flush-mounting box, wall-mounting box, etc.).
Attach the finish plate.
INSTALLATION
Initialisation with Easy Controller
Completion
24