DIY D12 Manual De Instalación página 4

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

As with any electrical product, care should be taken to guard against the
potential risk of fire, electric shock, and injury to persons. The following
cautions must be observed:
Local building or electrical codes may require modifications to the information provided.
You are required to consult the local building and electrical codes prior to installation. If this
information is not consistent with local building or electrical codes, the local codes should
be followed.
NEVER
install Mat under carpet, wood, vinyl, or other non-masonry flooring without embedding
it in thin-set, thick-set, or self-leveling mortar.
NEVER
install Mat in adhesives or glues intended for vinyl tile or other laminate flooring, or in
pre-mix mortars. It must be embedded in polymer-modified, cement based mortar.
NEVER
cut the heating wire. Doing so will cause dangerous overheating and will void the
warranty. The power lead may be cut shorter if necessary, but never remove completely
from the heating wire.
NEVER
bang a trowel or other tool on the heating wire. Be careful not to nick, cut, or pinch
the wire causing it to be damaged.
NEVER
use nails, staples, or similar to fasten the heating wire to the floor.
NEVER
attempt to repair a damaged heating wire, splice, or power lead using unauthorized
parts. Use only factory authorized repair parts and methods.
NEVER
splice one mat heating wire to another mat heating wire to make a longer mat. Multiple
mat power leads must be connected in parallel in a junction box or to the thermostat.
NEVER
install one mat on top of another or overlap the heating wire on itself. This will cause
dangerous overheating.
NEVER
forget to install the floor sensor included with the thermostat.
NEVER
install Mat in any walls, or over walls or partitions that extend to the ceiling.
NEVER
install mats under cabinets or other built-ins having no floor clearance, or in small
closets. Excessive heat will build up in these confined spaces, and the mat can be
damaged by fasteners (nails, screws, etc.) used to install built-ins.
NEVER
remove the nameplate label from the power leads. Make sure it is viewable for
inspection later.
NEVER
extend the heating wire beyond the room or area in which it originates.
NEVER
allow a power lead or sensor wire to cross over or under a heating cable. Damage
could result.
NEVER
put the system into full operation until the tile or flooring installer verifies all cement
materials are fully cured (typically two to four weeks)
ALWAYS completely embed the heating wire and factory splices in the floor mortar.
ALWAYS maintain a minimum of 2" spacing between heating wires.
ALWAYS pay close attention to voltage and amperage requirements of the breaker, the thermostat,
and the Mat. For instance, do not supply 240 VAC power to 120 VAC Mat as damage
will result.
IOM-ST-DIY-MAT 1515
4 of 96

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido