Operating instruction for 20t heavy-duty press:
Please inspect the product immediately after unpacking, and ensure that it is intact. If any component is lost or damaged, please
contact the Customer Service Department of SATA Automotive Technology (Shanghai) Co., Ltd. at 400-820-3885, 800-820-3885
Please write down the product serial number:________
Note: If no serial number is available, please write down the date of purchase.)
Please keep this Manual properly:
1)As this Manual covers safety warning, installation and operation, maintenance, common fault troubleshooting, etc. of the product,
please properly keep it.
2)Please write down the serial number (or date of purchase) of this product on the first page of the Manual, and keep it in a dry
and safe place for reference.
3)Please use the product correctly on the basis that you have fully understood the information contained herein.
4)The equipment has been covered by product liability insurance.
Safety warning:
1)Be sure to carefully read and fully understand the instructions herein before use. Incorrect operation may result in personal
injury and product damage.
2)Carefully check it before each use, and do not use it in case of oil leakage, and looseness or damage of parts and accessories.
3)Overloading is prohibited, otherwise the liability for accidents will not be covered by insurance.
4)The safety valve cannot be adjusted by the user. The liability for accidents caused by such operations is not covered by insurance.
5)Please keep children and other unauthorized personnel away from the working area.
6)Before pressing the workpiece, apply pressure slowly to ensure it is in reliable contact with the workpiece, and then apply pressure
quickly.
7)If any permanent deformation is found or is considered as possible to occur, stop using this press immediately.
8)Please use the equipment on a flat, level, dry and reliable plane.
9)The heavy-duty bolts are used on the press, and shall be replaced with genuine parts.
10)Please select correct pressing attachments such as the ram, block, socket and bearing.
11)Do not expose the product to rain or use it outdoors in any adverse weather conditions.
12)Please keep it away from heat and fire sources, as high temperature may damage the equipment and seal.
13)The untrained personnel are not allowed to operate the equipment. Do not disassemble or modify the equipment by yourself.
14)It is recommended to reasonably maintain the equipment by professional technical personnel with maintenance qualification. The
genuine parts shall be used for the necessary replacement.
15)Please wear safety shoes, goggles and working gloves conforming to relevant national safety regulations during operation, and SATA
products are recommended.
16)It is not allowed to use this product after drinking and in case of debilitation, inattention, drowsiness due to drugs and unconsciousness
Warning: The Notes, Warnings, Tips in this Instruction cannot cover all possible conditions.
The operator shall understand that careful operation and professional knowledge are indispensable to operation of this product.
8
AE5832
Product No.
Product name
Rated weight (kg)
Ram - working surface
Max. height (mm)
Ram - working surface
Minimum height (mm)
Moving distance of cylinder (mm)
Piston rod stroke (mm)
Net weight (kg)
Gross weight (kg)
Carton dimension (cm)
中文
EN
DE
AE5832
20t heavy-duty press
20,000
920
±5
40
175
185
112
136
169×71×27
RU
KO
PT
JA
ES