Koala Kare KB200 Instrucciones De Instalación página 4

Cambiador plegable
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

KB200
Step 2. Prepare Mounting Surface
Remove the bed and chassis from the box and
select the wall area where the unit will be installed.
Make sure you have taken into consideration the
operating clearance of 9½" (241 mm) on both sides
of the exposed chassis and 23 3/16" (589 mm)
from wall surface when open.
For Wood Stud Wall
Measure from the floor 42¼" (1073 mm) on stud
center and mark the wall. The mounting holes are
designed for 16" (406 mm) stud centers. Ensure
the locations you have marked for the mounting
holes are level before drilling. Drill pilot holes for
keyhole mounting using a 1/8" regular drill bit.
If the wall has wooden studs that are not on 16"
(406 mm) centers, you will need to use toggles to
secure one side of the unit. The other side should be
secured to the stud using the screws provided. You
must allow for space inside the wall for the toggles
to turn. This will vary depending on the toggles used.
For Masonry or Tile over Stud Wall
Use a 7/32" (5 mm) masonry drill bit for the pilot hole
until you hit the stud. Change bit to 1/8" (3 mm) regular
drill bit.
For Metal Stud or Concrete Block
If the wall has metal studs or an underlying surface
of concrete block, you will need to use toggles to
secure one side of the unit. The other side should be
secured to the stud using the screws provided. You
must allow for space inside the wall for the toggles
to turn. This will vary depending on the toggles used.
Installation Instructions
3
9
1 /2
"
(2 4 1 m m
"
2 3
3 /1 6
)
(5 8 9 m m
16"
(406.4mm)
Important:
In Step 3, all SIX
screws provided
must be mounted
to the chassis to
ensure proper load
bearing capacity!
Floor
)
(2 4 1 m m
Top two screws at
42¼" (107 cm) to
meet ADA Height
Requirements
9
1 /2
"
)

Publicidad

Tabla de contenido
loading

Tabla de contenido