Koala Kare KB200 Instrucciones De Instalación página 5

KB200 Installation Instructions
Step 3. Mount Bed and Chassis
Screw two of the mounting screws into the pilot
holes leaving ¼" (6.35 mm) exposed to allow
keyhole slots to be easily mounted over the screw
heads. Place chassis over screws as shown in
illustration. After securing the unit using the keyhole
slots, verify that the unit is level. Tighten top two
screws so that they are flush with the wall. Use the
four lower holes as a guide to mark and drill pilot
holes. Use remaining four screws and four washers
to complete installation of bed and mounting
bracket. Insert washers over lower four screws.
All SIX screws and four washers must be properly
mounted to the chassis.
Step 4. Install Liner Dispenser
Ensure liner dispenser is free from damage.
Remove key, unlock, and open liner dispenser lid.
This will expose liner dispenser mounting holes.
Line up dispenser mounting holes onto chassis
and secure with the four screws provided. Close
and lock the liner dispenser door.
Step 5. Complete Installation
Clean work area and inspect unit to ensure it
opens and closes smoothly. Give Operator Kit and
key to the facility operator.
Replacement Parts
For a list of replacement parts for this product,
(such as straps, shocks and labels) please visit
koalabear.com. Replacement parts and additional
liners can be purchased from your local
distributor or direct from Koala at koalabear.com.
4