Care And Cleaning; Flush System - Kohler K-1394-H2 Guía De Propietario

Ocultar thumbs Ver también para K-1394-H2:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation
Fill Whirlpool
Turn the jet trim fully counterclockwise. Position the jet nozzles so they face down toward the basin.
NOTICE: Do not allow the water temperature in the whirlpool to exceed 104°F (40°C). The heater will
automatically maintain the water temperature when the whirlpool is running, as long as the water
temperature does not exceed 104°F (40°C). The heater will disengage at higher temperatures.
Close the drain, then fill the whirlpool with water. For "Waterfall" mode only, fill the whirlpool at
least 2" (5.1 cm) above the top of the suction covers. For "Waterfall" or "Flexjet" mode less
"Riverjets", fill the whirlpool at least 2" (5.1 cm) above the top of the highest Flexjet. For all modes,
fill the whirlpool above the water-level sensors on either side of the Riverjets.
Using your hand, test the water temperature for comfort and safety. Carefully enter the bath.
Press the power icon to turn on the whirlpool pump and heater or rotate the outer ring to access a
desired mode.
Press the up or down arrow icons to increase or decrease the water flow. The indicator bar will
display the water flow volume.
Adjust the jets for optimum air/water mixture (when "Tidepool" mode is not activated). Turn the jet
trim clockwise to reduce the flow or counterclockwise to increase the flow. If desired, position the jet
nozzles to direct the water flow to maximize your hydro-massage experience.
NOTE: A built-in timer automatically stops the pump and motor after approximately 20 minutes of
operation.
If desired, turn the heater off by rotating the outer ring until the heater button is flashing and
pressing "OK." Press "OK" again to turn the heater back on.
Press the power icon a second time to turn off the whirlpool pump and heater.
Carefully exit the bath, then open the drain to empty the whirlpool.
NOTE: If the whirlpool is not operating properly, consult the "Troubleshooting" section of this guide
before calling a qualified service representative.
Remote Control
Refer to the Homeowners Guide packed with the remote control for proper operation.

Care and Cleaning

For best results, keep the following in mind when caring for your KOHLER product:
• Always test your cleaning solution on an inconspicuous area before applying to the entire surface.
• Wipe surfaces clean and rinse completely with water immediately after applying cleaner. Rinse and
dry any overspray that lands on nearby surfaces.
• Do not allow cleaners to soak on surfaces.
• Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring
pad to clean surfaces.
For detailed cleaning information and products to consider, visit www.kohler.com/clean. To order Care &
Cleaning information, call 1-800-456-4537.

Flush System

NOTE: Flush your whirlpool system twice a month or more, depending upon usage.
Turn the jet trim rings fully clockwise to remove air induction.
Fill the whirlpool with warm water above the backjet level probes or leave water in the whirlpool
after using.
Add 2 teaspoons (10 ml) of a low-foaming, powder automatic dishwasher detergent and 20 ounces
(590 ml) of household bleach (5% - 6% sodium hypochlorite) to the water.
1022209-5-E
6
Kohler Co.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

K-1394-h3

Tabla de contenido