SATA AE5831 Manual Del Uso página 8

Operating instruction for 20t press:
Please inspect the product immediately after unpacking, and ensure that it is intact. If any component is lost or damaged, please contact the
Customer Service Department of SATA Tools (Shanghai) Co., Ltd. at 400-820-3885, 800-820-3885
Please write down the product serial number:________
Note: If no serial number is available, please write down the date of purchase.
Please keep this Manual properly:
1. As this Manual covers safety warning, installation and operation, maintenance, common fault troubleshooting, etc. of the product, please properly
keep it.
2. Please write down the serial number (or date of purchase) of this product on the first page of the Manual, and keep it in a dry and safe place for
reference.
3. Please use the product correctly on the basis that you have fully understood the information contained herein.
4. The equipment has been covered by product liability insurance.
Safety warning:
1.Be sure to carefully read and fully understand the instructions herein before use. Incorrect operation may result in personal injury and product
damage.
2.Carefully check it before each use, and do not use it in case of oil leakage, and looseness or damage of parts and accessories.
3.Overloading is prohibited, otherwise the liability for accidents will not be covered by insurance.
4.The safety valve cannot be adjusted by the user. The liability for accidents caused by such operations is not covered by insurance.
5.Please keep children and other unauthorized personnel away from the working area.
6.Before pressing the workpiece, apply pressure slowly to ensure it is in reliable contact with the workpiece, and then apply pressure quickly.
7.If any permanent deformation is found or is considered as possible to occur, stop using this press immediately.
8.Please use the equipment on a flat, level, dry and reliable plane.
9.The heavy-duty bolts are used on the press, and shall be replaced with genuine parts.
8
AE5831
Product No.
Product name
Rated weight (kg)
Ram - working surface
Max. height (mm)
Ram - working surface
Minimum height (mm)
Moving distance of cylinder (mm)
Piston rod stroke (mm)
Net weight (kg)
Gross weight (kg)
Carton dimension (cm)
中文
EN
AE5831
20t press
20000
1010
±5
49
397
185
94.5
98
1# 155×19×14
2# 73×26×17
DE RU KO PT JA ES
透明度拼合