Bestway 58367 Manual De Instrucciones página 4

3. Attach the Hoses to the corresponding letters on the pool.
4. Attach the Hoses to the Sand filter by pressing the hose fitting on the pump port. Screwthe threaded locking rings into position; ensure the
corresponding letters on both the pool and the Sand filter match (A to A, B to B).
5. Remove the Stopper Plugs from the pool's inlet and outlet valves and insert with the Debris Screens (24).
6. With the Hoses and Debris Screens (24) in position, tighten the Hose Clamps (22).
GARDEN HOSE ADAPTOR FUNCTIONS
1
1. Assemble the garden hose adaptor.
2. Screw the garden hose adaptor onto port D of the sand filter.
3. Attach garden hose to the garden hose adaptor.
NOTE:
1. Garden hose adaptor can be used for draining your pool, and can only be assembled to port D of the sand filter.
2. Always switch off and unplug the sand filter before assembling the garden hose adaptor, and set the control valve to Closed position.
3. Ensure the washer is in position before assembling the garden hose adaptor.
Section I: Assembly (You will need a Phillips screwdriver).
1. Carefully remove all components from the package and check to ensure nothing is damaged. If equipment is
damaged, immediately notify the retailer from where the equipment was purchased.
2. The sand filter should be placed on solid, level ground, preferably a concrete slab. Position the sand filter so the
Ports and Control Valve are accessible for operation, servicing and winterizing.
3. EN60335-2-41 TEST standard requires the sand filter to be vertically fixed on ground or a certain pedestal made
of wood or concrete before use to prevent the sand filter from accidentally falling. Fully assembled sand filter will
exceed 35kg. The mounting holes should be 8mm in diameter and spaced 86mm apart. Use two bolts and nuts
with a maximum of 8mm in diameter to fasten the sand filter to the pedestal.
Load pool-grade filter sand.
NOTE: Use only special pool-grade filter sand, free of all limestone or clay: #20 Silica sand 0.45-0.85mm, approximately one 35kg bag should suffice.
If you do not use the recommended size of filter sand, filtering performance will be reduced and the sand filter may damaged, thereby voiding the warranty.
NOTE: To avoid damaging the Skimmer when adding sand, pour some water into the Bottom Tank to submerse the Skimmer on the Hub.
NOTE: SAND NOT INCLUDED.
20
10
1. Place the tank base in the right place,
aligning the position hole.
4
5. Pull out the filter cover(4)
6. Lower the control valve over the tank slowly,and
2. Place the tank onto the right place of tank base.
6
ensure the bypass pipe protruding underneath
the control valve fits securely into the hub(6)
2
3.Place the filter vover(4)
C
7. Make sure Port C on the Control Valve is align
Port C on the Pump. Attach the Top Flange
Clamp(3) and screw into position.
4
3
Ф8mm
4
4
MAX
MIN
4. Slowly add the sand so the weight of the sand does
not damage the Skimmer on the Hub, until it reaches
between the marked "MAX" and "MIN". #20 Silica
sand 0.45-0.85mm, approximately 35 kg.
14
3
8. Attach the Piping(14) to Pump Port C and to
Control Valve Port C, screw the threaded
locking rings into position. Make sure the
Washer is properly positioned on both ends
of the Piping(14).
86mm
MAX
MIN
C
S-S-004292