Operation - Husky H4430 Guía De Uso Y Cuidado

Operation

1
Operating the impact wrench
□ This 1/2" Impact Wrench is designed to operate on 90 PSIG .
Lower pressure (below 90 PSIG) will reduce performance
of the tool . Higher air pressure (over 90 PSIG) raises the
performance of the tool beyond its rated capacity and
could cause serious damage to the tool and the user .
3
Changing the output torque level
□ This tool features the air regulator to manage the output
power .
□ Press the air regulator in, then adjust to your desired
torque level .
□ 1 means minimum torque and 4 means the full power .
3
4
2
1
2
Changing the output torque direction
□ This tool features the reverse switch to change the
output torque direction to tighten (assemble) or loosen
(disassemble) the bolt or fastener .
□ Control the output torque direction by pushing the reverse
switch button to the F (Forward) or R (Reverse) position to
change the direction .
4
Installing and removing the impact
sockets
WARNING: Disconnect the tool from the air supply before
servicing or changing accessories . Always use sockets rated
for impact wrenches .
To install the impact socket:
□ Disconnect the tool from the air source .
□ Select the suitable and desirable socket size .
□ Press fit the anvil into the socket .
□ To remove the impact socket:
□ Disconnect the tool from the air source .
□ Use your hand or a suitable tool to remove the socket .
6