Adjusting The Idle Speed; Maintaining The Spark Plug - Snapper 7800959-00 Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ADJUSTING THE IDLE SPEED

WARNING:
Wear protective clothing and observe all
safety instructions to prevent serious personal injury.
NOTE: Careless adjustments can seriously damage the unit. A qualified
service dealer should make carburetor adjustments.
If, after checking the fuel and cleaning the air filter, the engine still
will not idle, adjust the idle speed screw as follows:
1. Start the engine. Refer to Starting and Stopping.
2. Move the cruise control to the SLOW position and let the engine
idle. If the engine stops, use a small Phillips screwdriver to turn
the idle speed screw clockwise, 1/8 of a turn at a time (as
needed) until the engine idles smoothly (Fig. 14).
3. If the engine is idling too quickly, turn the idle speed screw
counterclockwise, 1/8 of a turn at a time (as needed) to reduce the
idle speed (Fig. 14).
Checking the fuel, cleaning the air filter, and adjusting the idle speed
should solve most engine problems. If not, and any of the following
conditions are true, take the unit to a qualified service dealer:
the engine will not idle
the engine hesitates or stalls on acceleration
there is a loss of engine power

MAINTAINING THE SPARK PLUG

1. Stop the engine and allow it to cool. Grasp the spark plug boot
firmly and pull it from the spark plug.
2. Clean around the spark plug. Remove the spark plug from the
cylinder head with a 5/8-inch socket, turning counterclockwise.
WARNING:
Do not sand blast, scrape or clean spark plug
electrodes. Grit in the engine could damage the cylinder.
3. Inspect the spark plug. If the spark plug is cracked, fouled or dirty,
replace it with a Champion RDJ7J or an equivalent spark plug.
4. Use a feeler gauge to set the air gap at 0.025 in. (0.635 mm)
(Fig. 15).
5. Install the spark plug in the cylinder head. Tighten the spark plug
with a 5/8-inch socket, turning it clockwise until snug.
NOTE: If using a torque wrench, torque to:
110-120 in.•lb. (12.3-13.5 N•m). Do not over tighten.
6. Reattach the spark plug boot.
0.025 in.
(0.635 mm)
13
Idle Speed Screw
Fig. 14
Fig. 15

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido