Important Safeguards; Important Safety Precautions - Faro Barcelona OVNI Instrucciones

INSTRUCCIONES DE SEGURIDAD / INSTRUCTION DE SÉCURITÉ / SAFETY INSTRUCTIONS / INSTRUÇÕES DE SEGURANÇA / SICHERHEITSHINWEISE /
VEILIGHEIDSINSTURCTIES / INSTRUZIONI DI SICUREZZA / Ο∆ΗΓΊΕΣ ΑΣΦΑΛΕΊΑΣ / ИНСТРУКЦИИ ПО ТЕХНИКЕ БЕЗОПАСНОСТИ
● ENGLISH ●
CAUTIONS
GENERAL INSTALLATION AND OPERATION INSTRUCTIONS

IMPORTANT SAFEGUARDS:

1- To ensure the success of the installation, be sure to read the instructions and review the diagrams thoroughly before beginning.
2- To avoid possible electric shock, be sure electricity is turned off at the main power box before wiring. All electrical connections must
be made in accordance with local codes, ordinances and/or the National Electric Code. If you are unfamiliar with the methods of
installing electrical wiring and products, secure the services of a qualified and licensed electrician as well as someone who can check
the strength of the supportive ceiling members and make the proper installation(s) and connections.
3- Make sure that your installation site will not allow rotating fan blades to come in contact with any object. Blades should be at least 7
feet from floor when fan is operating.
4- If possible, mount ceiling fan on a ceiling joist – the joist must be able to support the motion and weight of the moving fan. If the fan
will be mounted on a ceiling outlet box, a 4´ x 2-1/8´deep METAL octagon box is required, one UL listed as "suitable for fan support".
The box must not be able to twist or work loose. DO NOT USE PLASTIC BOXES.
Installation on a concrete ceiling should be performed by qualified personnel.
5- Blades should be attached after motor housing is hung and in place. To protect its finish fan motor housing should be kept in carton
until ready to be installed. If you are installing more than one ceiling fan, make sure that you do not mix fan blade sets.
6- After making electrical connections spliced conductors should be turned upward and pushed carefully up into outlet box. The wire
should be spread apart with the grounded conductor and the equipment-grounding conductor on one side of the outlet box, and the hot
wire to the other side.
7- Electrical diagrams are for reference only. Light kits that are not packed with the fan should be UL listed and should be installed per
the light kit's installation instructions.
8- After fan is completely installed, check to make sure that all connections are secure to prevent fan from falling and/or causing
damage or injury.
9- The fan can be made to work immediately after installation, the bearings are adequately charged with grease so that, under normal
conditions, further lubrication should not be necessary.
10- The fan must be turned off and stopped before reversing fans direction.

IMPORTANT SAFETY PRECAUTIONS

Thank you for choosing a FARO Ceiling Fan. You have chosen the best! Your new ceiling fan has been designed to provide many
years of service and enjoyment.
WARNINGS:
• Disconnect power by removing fuse or turning off circuit breaker before installing the fan and/or optional lighting.
• To reduce the risk of fire, electrical shock, or personal injury, mount only to an outlet box marked "acceptable for fan support".
• If you choose a wall control, use an appropriate speed control device designed for use with ceiling fans to reduce the risk of fire,
electrical shock, or personal injury. DO NOT USE A SIMPLE INCANDESCENT LIGHT DIMMER OR SOLID-STATE SPEED CONTROL
DEVICE.
• To reduce the risk of personal injury, do not blend the blade brackets when installing them, balancing the blades or cleaning the fan.
Do not insert any object(s) between rotating ban blades.
NOTE:
The important precautions, safeguards and instructions appearing in this manual are not meant to cover all possible conditions and
situations that may occur. It must be understood that common sense, caution and carefulness are factors which cannot be built into this
product. These factors must be supplied by the person(s) installing, caring for and operating the unit.