Selecting The Operating Function; Cooling - BALAY 3XD620H Instrucciones De Uso

Instructions for use
Selecting the operation function
The following functions can be selected on
your appliance:
air conditioning.
dehumidification.
air purification.
Place the selection box on the Operation
Function menu using the
(see "Navigation":
Use the and keys to move on the
menu and select the desired function (see
"Navigation": and
Function air conditioning
In this function, the appliance reduces
ambient temperature until the desired
temperature is reached. The appliance
dehumidifies and purifies the air in the
room at the same time in order to create a
pleasant atmosphere.
To do this:
Fig. 25
• Check that the hose, the electrical
connection and the water tube are
properly connected to the indoor unit.
• Make sure that plugs N, Fig. 1 and C,
Fig. 2, are in their housings to prevent
water from leaking onto the support
surface.
• Turn the appliance on by pressing the
key.
• Lift the air director on the top of the
appliance Fig. 24, and, if you wish, open
the side fins, see A and L, Fig. 1 (see
"Side fins"), for enhanced air distribution
within the room. It is recommended that
these air outlets be left fully open or fully
closed in order to prevent unpleasant
noise.
and keys
and keys).
keys).
• Select the air conditioning function
(see "Selecting the operation function").
• Select the desired temperature, (see
"Selecting the temperature"). If the
appliance turns itself off automatically
because the desired temperature for the
room has been reached, it will not start
working again until ambient temperatur e
rises 2-3°C.
• Finally, make sure that the flexible hose
which joins the two units is not crushed
or restricted, that the difference in
height between the units does not
exceed 1.5 m, Fig. 11, and that the
outdoor unit is not lower than the indoor
unit, Fig. 12.
• Select the operation speed, (see
"Selecting the speed").
Condensed water normally evaporates
through the outdoor unit. If there is too
much water, it may not be possible to
expel it all. If this happens, it accumulates
on the base of the outdoor unit and may
drip. Do not worry, this is normal. Simply
place a receptacle beneath nozzle C Fig.
2, and remove the accumulated water.
When the water in tank Q, Fig. 1, reaches
a certain level, the appliance beeps twice
and the tank full symbol
the screen to indicate that it needs to be
emptied. The appliance stops working
when this happens. To empty the
removable tank, carefully remove it and
empty it down the nearest drain.
Important!
When you turn the appliance back on
again, do not forget to fit the tank
back onto the appliance properly.
Should you fail to do so, the symbol
will not disappear from the screen and
the appliance will not work.
Remember that when the appliance is
turned off and turned back on, it is
necessary to wait for approximately 3
minutes before the compressor starts
up again. This period of time is
required in order to ensure correct
appliance operation.
63
,
appears on