UFESA PV3200 Manual De Instrucciones página 13

3
The Heater Light will come on.
The light will go off once the required
temperature is reached.
● The iron is ready for use.
4
Use the Steam Control to set the required amount
of steam.
SPRAYING
This function can be used any time
without affecting any other settings.
1
Fill the water tank. See the "FILLING THE IRON
WITH WATER" section.
2
Aim the nozzle at the garment.
3
Press the Spray Button.
It may be necessary to press the spray
button a few times to start spraying.
STEAM BURST
This function ensures extra amount of steam to remove
stubborn wrinkles (creases) from the ironed fabrics.
1
Proceed as described in "Before first use" section.
2
Turn the Temperature Dial to "●●" or "●●●".
3
The Heater Light will come on.
The light will go off once the required
temperature is reached.
● The iron is ready for use.
4
Press the Steam Burst Button – steam will burst
from the holes of the soleplate.
5
For stubborn wrinkles, wait a few seconds and
press Steam Burst button again.
Most wrinkles can be removed within
three presses.
It may be necessary to press the Steam
Burst Button a few times to engage this
function.
For optimum steam quality, do not press
the Steam Burst Button more than three
times after the heater light goes off.
STEAM BURST IN VERTICAL POSITION
This function provides extra amount of steam for
removing creases from delicate fabrics in hanging
position (hanging curtains or other hanging fabrics).
The steam generated by the iron has
very high temperature. Never use the
appliance for ironing clothes or fabrics
while they are being worn by people or
pets. Never aim the steam at people or pets.
1
Proceed as described in the "Before First Use"
section.
2
Turn the Temperature Dial to "●●●".
3
The Heater Light will come on.
The light will go off once the required
temperature is reached.
● The iron is ready for use.
4
Hold the iron between 15 and 30 centimetres away
from the garment.
5
Press the Steam Burst Button - steam will shoot
from the holes of the soleplate.
6
For Stubborn wrinkles, wait a few seconds before
pressing the Steam Burst Button again.
Do not press the steam burst button
when the light is on. Additional steam
can be generated only when the light
goes out.
Most wrinkles can be removed within
three presses.
It may be necessary to press the Steam
Burst Button several times to start this
function.
For optimum steam quality, do not press
the Steam Burst Button more than three
times in a row.