Information About Operation - Trix BB12000 Serie Manual De Instrucciones

Functions
The locomotive offers the following features:
• Built-in electronic circuit for operation with a conven-
tional DC power pack (max. ±12 volts), Trix Systems,
Trix Selectrix or NMRA DCC digital systems.
• The mode of operation is automatically recognized.
• Headlights for the locomotive change over with the
direction of travel. They can be turned on and off in
digital operation.

Information about operation:

• Minimum required radius for this model:
356 mm / 14-1/8".
• Handle the delicate pantographs and applied detail
parts with care. The thin supports are easily bent.
• The prototypical coupler hooks and brake lines included
with the locomotive are to be installed on the locomotive
only when it is to be used as a display piece.
• This locomotive is only to be used with the operating
system it is designed for.
• The locomotive must not be connected to more than
one power source at a time.
• Pay close attention to the safety warnings in the
instructions for your operating system.
Notes on digital operation:
• This locomotive comes from the factory program-
med for the digital address "06" (Selectrix) / "06"
(DCC). Number of speed levels that have been set:
28 (DCC) and 31 (Selectrix).
6
• Information about DCC Operation:
The setting done at the factory does not permit
operation with opposite polarity DC power in the
braking block. If you want this characteristic, you
must do without conventional DC power operation
(CV29 / Bit 2 = 0).
• Trouble-free programming of the decoder can only
be guaranteed when it is done with original Trix
Selectrix components.
• The train has a technical feature in DCC operation in
which its lights will go on when the lighting function
is turned off and the train is stopped in a block.
• When using a multiprotocol digital central unit as an
operating system, this locomotive should be cont-
rolled with DCC format. The Selectrix digital central
unit allows Selectrix format to be employed.
The necessary maintenance that will comes due with
normal operation is described below. Please see your
authorized Trix dealer for repairs or spare parts.
No warranty or damage claims shall be accepted in those ca-
ses where parts neither manufactured nor approved by Trix have
been installed in Trix products or where Trix products have been
converted in such a way that the non-Trix parts or the conversion
were causal to the defects and / or damage arising. The burden of
presenting evidence and the burden of proof thereof, that the in-
stallation of non-Trix parts or the conversion in or of Trix products
was not causal to the defects and / or damage arising, is borne by
the person and/or company responsible for the installation and /
or conversion, or by the customer.