Transcend 3 miniCPAP Guía Rápida página 9

Transcend 3 miniCPAP Quick Guide
USB port
Power jack
Note: It may be necessary to unplug the cables and reconnect to ensure a good
connection.
Using the Transcend 3 miniCPAP
The control panel of the Transcend 3 miniCPAP has two pushbuttons that activate the
blower and initiate the pressure ramp feature. There are also two LED lights, including a
green LED for indicating normal operational modes and a yellow LED for indicating fault
conditions. The Transcend 3 miniCPAP operational status is displayed by LED illumination
states.
When a power source is connected to the device the Transcend 3 miniCPAP power-up LED
flash sequence should initiate. Once the power-up LED flash sequence is complete the
LED lights will turn off. This sequence indicates that power is being supplied to the
Transcend 3 miniCPAP and that it has successfully entered Standby Mode. During therapy
delivery, the LED lights remain off to avoid disturbing the patient and/or bed partner.
Note:
If the Transcend 3 miniCPAP loses power while delivering therapy, it will
resume delivering therapy as soon as power is restored and you press the power
button. The device will repeat the power-up LED flash sequence prior to the
blower restarting.
Standard User Modes
Normal operation consists of four modes:
Off When the device is not connected to a power source the device is off. Control
panel LEDs are both off.
Page 9