Kohler K-18597 Guia De Instalacion página 7

Finished Wall
Underside of Vanity
4. Install the Vanity
CAUTION: Risk of personal injury. Do not attempt to lift
the vanity into place without assistance.
Lift and slide the vanity or vanities over the brackets.
Ensure the back of the vanity is flush against the finished wall
and the brackets are properly positioned underneath the vanity.
Using a 1/16" bit, drill pilot holes for the screws; use care not to
drill through to the top of the vanity.
From the underside of the vanity, secure the brackets to the
vanity with the screws provided. Use a flashlight to assist you.
If a Lavatory/Vessel Will NOT Be Installed:
Attach bumpers (provided) to the top left and top right corners of
the backside of the drawer/lid face. Reinstall the drawer. To
properly reinstall the drawer, refer to the "Remove/Adjust the
Drawer" section.
If a Lavatory/Vessel Will Be Installed:
Proceed to the "Prepare for the Lavatory Installation" section to
install a lavatory or vessel.
Kohler Co.
Access Holes
Vanity
Screw
Bracket
7 1055673-2-C