Tabla de contenido
Publicidad
2. FUNCTION OF THE KEYS
The 4 frontal keys allow accessing the functions and the settings of the device and vary their function
depending on the operating mode of the video intercom. The keys can be used in two different ways:
2.1 Function of the keys in the different operating modes of the video intercom
Depending on the operating mode, the keys of the video intercom carry out the following functions:
Key
Standby
Short
Execute a Monitoring function; if planned on the system diagram, the video intercom switches ON in the last external station where
press
a call was made.
Long
Enable/disable the "Silent" function: exclusion of the ringtone and the tones of the device. When the "silent" function is enabled
press
and the video intercom is ON, the icon
Short
press
Close the contact between terminal CII and terminal PII or, if appropriately configured on the video intercom and planned on the
system wiring, Executes a second Monitoring function (see Adjustments paragraph).
Long
press
Short
press
Operate the Electrical Lock of the last external station that has carried out a call.
Long
press
Short
press
No operation.
Long
press
1) short press (under 2 seconds)
2) long press (over 3 seconds).
Attention. During the pressing of a key, a dissuasion or busy tone warnings that the function
is not available because the service is not active or the video intercom line is busy by
another user.
Monitoring
flashes (see paragraph 3.2.3).
Enable the Conversation with the external station.
Ringtones programming (see par-
agraph 3.2.1).
Short press: < 2 seconds
Long press: > 3 seconds
Operating Modes
Ringing
Programming of ringtone volume
(see paragraph 3.2.2).
- 10 -
<2 Sec.
>3 Sec.
Conversation
Close the Conversation with the
external station.
Programming of audio conversa-
tion volume (see paragraph 3.1).
Mi 2556
Publicidad
Tabla de contenido
