Bell DASHBOARD 300 Manual Del Usuario página 10

additional function modes
10
Freeze FraMe MeMOry –
the display at the end of a ride segment and information TM, DST and AVS which will
be flashing, can be read at a later time by the RIGHT key. To release the memory, press
the LEFT key until the display digit is static again. This is particularly useful when
crossing the finish line of a time trial, since the TM cannot be stopped manually.
ODOMeter SaVe FunCtiOn–
tant data of total distance (ODO) even after battery replacement. To set ODO, after
battery replacement and wheel size setting, press RIGHT button to ODO mode and
then hold LEFT button for 2 seconds until the last digit flickering. To adjust number,
press the RIGHT button and then press the LEFT button to confirm and select digit to
be input. Repeat this sequence to reach the desired odometer value. Press the LEFT
button again to return to normal ODO mode.
autO StOp/Start–
To preserve batteries, the cycle computer will automatically
switch off if the unit is left unused for over 5 to 6 minutes. Display will reappear with a
press on either button or input from the sensor.
Press the LEFT button, Freeze Frame Memory can lock
The SAVE function allows you to keep the impor-