Care And Cleaning; Troubleshooting - Glacier bay FW6AC012CP Guía De Instalación Y Cuidado

Care and Cleaning

□
To clean, wipe down with a damp cloth and towel dry.
□
Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will
be voided.

Troubleshooting

NOTE: Refer to the service parts section in this manual for a
detailed drawing showing the location of the parts listed below.
Problem
There are leaks from the
handle.
The aerator leaks or has a
reduced water flow.
The sink drain at the base of
the sink is leaking.
The water will not shut off
completely.
Possible Cause
□
The bonnet nut is loose.
□
The O-ring on the cartridge is
dirty or damaged.
□
The aerator is dirty or mis-fitted.
□ The cartridge may be clogged.
□ The sink surface is rough or
irregular.
□ The cartridge bonnet nut
is loose or cartridge is not
positioned correctly.
□ The cartridge is damaged.
□
Tighten the bonnet nut.
□
Clean or replace the O-ring.
□
Remove the aerator and check for
debris.
□ Remove cartridge and check for
debris.
□ Ensure the aerator is properly
installed.
□ Apply additional silicone sealant to
the beveled side of the drain flange.
□ Apply silicone sealant to the beveled
side of the rubber washer on the
drain body.
□
Retighten and test for leaks.
□ Reinstall the cartridge after cleaning
and tighten the bonnet nut.Tighten
lock nut.
□ If problem still exist, replace the
cartridge.
10
Solution