Carl Stahl Kromer XBT Traducción De Las Instrucciones De Servicio página 13

EN
 Damage or visible wear could threaten your safety, and could reduce the service life of
the machine. Stop using the machine until it is repaired, and contact your supplier or
our service hotline to ask what you should do next.
 Improper repairs, or making structural changes to the machine, could influence machine
safety or be dangerous.
DANGER!

NEVER release the hand or foot loops or the cables on the XBT in
an uncontrolled manner.

Always attach or detach the hand and foot loops while the cable is
FULLY retracted. NEVER detach the hand and foot loops while the
cable is extended. Extended cables can spring back with an ex-
tremely high level of energy.

When a cable springs back, this creates a significant risk of injury,
and can also make it impossible to correctly extend the cable in the
future. Immediately stop working out with the XBT and put up a sign
stating that the machine is out of order.
Attaching the Hand and Foot Loops
 Before putting on the XBT, connect the hand and foot loops to the two spring balancers
and check to ensure the cables are fastened correctly. Ensure that the left and right
loops are attached to the correct left and right spring balancers. The hand loops are at-
tached at the top, where the display is also located. The foot loops are attached below
accordingly. You can see the exact points where the cables and loops are attached on
the images.
Foot loops
13
Operating Instructions
Hand loops