Test Mode - Samsung DV405 Información Técnica

ALIGNMENT AND ADJUSTMENTS
To avoid risk of electrical shock, personal injury or death; disconnect power to dryer before
servicing, unless testing requires power.

TEST MODE

Service Mode (DV405, DV398, DV395, DV393 only)
How to enter:
-
To enter Service Mode , press Mixed Load Bell + Temp. Keys 3 seconds in normal mode until it
sends out a beeping sound.
-
If pressing Mixed Load Bell + Temp. Keys in Service mode , it will return Normal mode.
-
Even though entering Service mode, the operating cycle will not be influenced.
DR Ready Modem Wire Test(DV431AS* only)
How to enter:
-
After entering Service Mode, press the Wrinkle Prevent button to start the Wire Test.
- During the test, "----" is displayed.
- If the test result is normal after the test, "SG" is displayed.
-
If a problem occurs, the "AE3" error code is displayed.
Touch Sensor Data Display Mode
Definition of Touch Sensor Data Display Mode:
-
This mode is default mode of entering service mode.
How to enter:
- With Power On pressing Mixed Load Bell +Temp(DV405, DV398, DV395, DV393) or Wrinkle
Prevent + Temp(DV231, DV365) for 3 seconds.
-
This action will put the dryer into sensor bar touch data mode
-
Dryer will display Sensor Bar data.
Cycle Count Mode
Definition of Cycle Count Mode:
- This mode is to bring up the total number of cycles that User have carried out.
How to enter:
- Press the Mixed Load Bell(DV405, DV398, DV395, DV393) orTime(DV231,DV365) key in Service
Mode.
Software Revision Mode
Definition of Software Revision Mode:
- It is to retrieve its software version
How to enter:
At Service Mode, press Temp until it sends out a beeping sound
ex) In case of "U1 05", U1 means major version "U1", 05 means minor version "05".
- If press Temp key In Software Version Mode, it will return Service Mode.
(Technical)DV405-02365H-03_EN_130221.indd 3
WARNING
3
2013-02-21 5:31:59