Installing The Side Vent Kit - LG DLEX3250 Serie Manual Del Usuario

18
INSTALLATION INSTRUCTIONS

Installing the Side Vent Kit

WARNING
manual could result in property damage, injury to
persons, or death.
Your new dryer is shipped to vent to the rear.
It can also be configured to vent to the bottom or side
(right-side venting is not available on gas models).
An adapter kit, part number
purchased from your LG retailer. This kit contains the
necessary duct components to change the dryer vent
location.
1. Remove the rear exhaust duct retaining screw. Pull
out the exhaust duct.
Rear
Exhaust Duct
Option 1: Side Venting
2. Press the tabs on the knockout and carefully remove
the knockout for the desired vent opening (right-
side venting is not available on gas models). Press the
adapter duct onto the blower housing and secure to
the base of the dryer as shown.
Adapter
Duct
faces AWAY from the dryer. Insert the elbow/duct
assembly through the side opening and press it onto
the adapter duct. Secure in place with duct tape.
Attach cover plate to the back of the dryer with
included screw.
, may be
Cover
Plate
Option 2: Bottom Venting
Retaining
2. Press the adapter duct onto the blower housing and
Screw
secure to the base of the dryer as shown.
that the male end of the elbow faces down through
hole in the bottom of the dryer. Secure in place with
duct tape.
Attach the cover plate to the back of the dryer with
included screw.
Cover
Plate
Elbow
Adapter
Duct
Elbow
1 1/2 "