36
HOW TO USE
Custom program
If you have a special combination of settings that you
use frequently, you can save these settings as a custom
program.
* To save a custom program:
1. Turn on the dryer and turn the cycle selector knob to
select the desired cycle.
2. Use the cycle setting buttons to adjust the settings for
that cycle.
would like to add. A confirmation message will be
shown in the display.
seconds.
NOTE
You may save only one custom program at a time.
Pressing and holding the CUSTOM PROGRAM button
will overwrite any previously saved custom program.
To recall a custom program:
1. Turn on the dryer.
2. Press the CUSTOM PROGRAM button.
Steam functions
To Fill the Steam Feeder
1. Pull out the drawer.
2. Lift out the steam feeder.
Steam
Feeder
4. Place the steam feeder in the drawer; then push in the
drawer until it clicks into place.
NOTE
filled with water up to the MAX line. If not, the
error will be displayed. If you see the error,
make sure that the steam feeder is filled with water
and the drawer is fully closed. Turn the dryer off then
restart the Steam Cycle.
Drawer
foreign substances, rinse agents, or detergents.
is empty.
the steam generator will not work.
otherwise water will overflow.
and the drawer before starting the dryer.
WARNING
can cause serious injury or death.
follow this warning can cause serious injury or death.
Water
ONLY
Failure to follow this warning
Failure to