Replacing Batteries - Honeywell 5901 Manual De Instrucciones

SETUP
STEP 1. OPEN SAFE DOOR
All new safes are shipped with the door unlocked. If the door has become locked during
shipping, open it with the override key as follows:
USING THE OVERRIDE KEY:
Remove small sticker (A) exposing cover screw.
1.
Remove screw (B) with small Phillips screwdriver.
2.
Lift keypad cover (C) to expose access keyhole (D).
3.
Insert override key and turn left to unlock safe.
4.
Turn knob to right and open safe door.
5.
STEP 2. INSTALL BATTERIES
Remove battery (A) cover on inside door.
1.
Insert 4 "AA" batteries (included).
2.
Replace the battery cover.
3.
Do not close door before testing digital lock.
4.
STEP 3. TEST DIGITAL LOCK
With door open, turn knob left to put locking door bolts (B) in lock position.
1.
Enter the preset pass code: "1"-"5"–"9"-"B" .
2.
Turn knob to right within 5 seconds.
3.
Lock bolts should recede into the unlocked position.
4.
STEP 4. PROGRAM A NEW PASSCODE
With door open, press reset button (C) inside door.
1.
Yellow light is on, enter new pass code in 30 seconds.
2.
Enter new code (3 to 8 digits) followed by "A" or "B".
3.
Safe will beep and yellow light will turn off.
4.
NOTE: The factory pre-set code will not work after a new pass code is programmed.
OPERATION
TO OPEN THE SAFE
To unlock and open safe, enter the pass code followed by "A" or "B".
1.
Turn door entry knob to the right and open door.
2.
TO CLOSE THE SAFE
Close the door and hold it in the closed position.
1.
Turn door entry knob to left to engage the lock bolts and lock safe.
2.
SECURE LOCKOUT PERIODS
If a wrong code is entered three times in a row, the digital keypad will begin a five-minute
secure lockout period. During this secure lockout period the keypad will become disabled.
Once the lockout period has expired, the safe can be unlocked using the correct pass code.
You may use the override key to open safe, but keypad will complete the full lockout period.
OVERRIDE ACCESS KEY
If the pass code is unavailable or your keypad fails due to dead batteries or other malfunction,
you can open the safe using the override access key (see STEP 1. in the SETUP section).

REPLACING BATTERIES

Note: The pass code will not be erased if the batteries become weak or are removed.
To replace the batteries please follow the instructions in STEP 2. in the SETUP section. If
your batteries are completely dead and you cannot open the safe by using the digital keypad,
use the override access key to open safe and access the battery compartment.
NOTE: It is NOT RECOMMENDED to use Non-alkaline or rechargeable batteries.
IF YOU FORGET THE PASSCODE
Use the override access key to open safe.
1.
With door open, press red reset button (C) inside door.
2.
Yellow light is on; enter new pass code in 30 seconds.
3.
Enter pass code (3 to 8 digits) followed by "A" or "B".
4.
Safe will beep and yellow light will turn off.
5.