Axxess AX-ADGM01 Instrucciones De Instalación página 3

Installing the Interface
• Connect the Green/Black wire to
the left rear negative wire of the
aftermarket radio.
12-Way Harness:
This harness is for the ASWC-1
(sold separately). Please refer to the
ASWC-1 instructions for programming.
Installing the AX-ADGM01
1. With the connections completed,
plug the 22- and 16-pin
harnesses into the AX-ADGM01
2. Plug the 30-pin GM harness into
the vehicle side harness, and plug
the aftermarket radio harness into
the aftermarket radio
3. Reconnect the negative
battery terminal.
4. Initialize the interface by cycling
the key by turning the ignition on
for 30-seconds then back off, and
then back on again to test the radio.
INSTALLATION INSTRUCTIONS FOR PART AX-ADGM01
Backup camera harness
Connect the Yellow RCA to the
aftermarket radios backup camera
video input.
RSE harness
Connect the "From rear A/V input"
RCA's to the aftermarket radios audio/
video input. Plug Yellow in to video
in, Red to right audio in, and White to
left audio in. Connect the "To overhead
screen" RCA's to the aftermarket radios
audio/video output. Plug Yellow in to
video out, Red to right audio out, and
White to left audio out. Connect the
Black wire with the ring terminal
to ground.
Video and RSE Harness
OE Satellite (if equipped)
• To listen to the factory satellite,
change the source of the radio
to AUX.
• Press and hold the SOURCE button
for three seconds.
• The driver's information center,
located in the center of your
instrument cluster, will now display
your satellite information.
• To exit Satellite mode press and hold
SOURCE for (3) seconds.
3
Listed below are the functions of the
steering wheel controls:
Source - Changes source of the radio/
enters and exits Satellite mode
Track up - Changes track on radio/
satellite station
Track down - Changes track on radio/
satellite station
Volume up - Enter
Continued on back