Cree C-LITE C Serie Instrucciones De Instalación

INSTALLATION INSTRUCTIONS
C-VT-B Series
Ceiling Mount
CAUTIONS
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions
should always be followed including the following:
READ AND FOLLOW ALL
SAFETY INSTRUCTIONS
1. DANGER- Risk of shock- Disconnect power before installation.
DANGER – Risque de choc – Couper l'alimentation avant
l'installation.
2. This luminaire must be installed in accordance with the NEC
or your local electrical code. If you are not familiar with these
codes and requirements, consult a qualified electrician.
Ce produit doit être installé conformément à NEC ou votre code
électrique local. Si vous n'êtes pas familier avec ces codes et
ces exigences, veuillez contacter un électricien qualifié.
SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE
Wall Mount
http://lighting.cree.com/warranty
Document:
Created By:
CEILING MOUNTING
1. Remove ceiling box from housing by removing (4) screws. See
Figure 1.
2. Attach conduit to desired threaded opening on back or side of
ceiling box. Teflon tape should be used to produce a watertight
seal.
NOTE: Be sure any unused threaded openings are closed with
plugs provided.
3. Attach the ceiling box to the mounting surface using (2)
1/4" (6 mm) fasteners, customer supplied, through the ears on the
box. Fasteners should be appropriate for the mounting surface.
4. Pull supply leads to ceiling box.
5. Complete the wiring per the Electrical Connections section.
6. Attach the housing to the ceiling box by installing the screws
removed in Step 1. Screws should be tightened in a diagonal
pattern to ensure uniform gasket compression. Tighten screws to
20 in-lbs (2.26 N·m).
WALL MOUNTING
1. Remove wall box from arm/housing by removing (4) screws. See
Figure 2 on the back page.
2. Attach conduit to desired threaded opening on back or side of
wall box. Teflon tape should be used to produce a watertight seal.
NOTE: Be sure any unused threaded openings are closed with
plugs provided.
3. Attach the wall box to the mounting surface using (2)
1/4" (6 mm) fasteners, customer supplied, through the ears on the
box. Fasteners should be appropriate for the mounting surface.
4. Pull supply leads to wall box.
Complete the wiring per the Electrical Connections section.
5.
6. Attach the arm/housing to the wall box by reinstalling the screws
removed in Step 1. Screws should be tightened in a diagonal
pattern to ensure uniform gasket compression. Tighten screws to
20 in-lbs (2.26 N·m).
FIGURE 1
| 866.924.3645
Date
DCR#
Ceiling box
Housing